6
Connecting the WirelessHD transmitter
and receiver
To connect the WirelessHD transmitter and receiver:
1 Connect up to 4 HDMI enabled source
components, such as a Blu-ray/DVD player,
cable/satellite box, gaming console, laptop,
etc., to the HDMI input jacks on the transmitter,
using high-speed HDMI cables.
2 Connect the display device, such as a TV or
projector, to the receiver with a high-speed
HDMI cable.
3 Connect the AC power adapters to the
transmitter and receiver and to power outlets.
Note: The included AC adapters are labeled “Receiver”
and “Transmitter,” to ensure that the correct adapter is
used for each device.
4
Power on your TV or projector and switch to
the HDMI input that the WirelessHD receiver is
connected to.
5 Power on at least one source component that
is connected to the WirelessHD transmitter.
6 Power on the WirelessHD transmitter and
receiver. The HDMI input port LED on the
transmitter should light continously (stop
blinking) to indicate that the desired input is
selected with active video. If this selection does
not occur automatically, please use the
included remote control or HDMI Select Switch
on back of the transmitter to select the desired
input port. See step 5 in “Using the WirelessHD
Kit” section on page 7.
Note: The transmitter and receiver are pre-paired and
should discover each other shortly after being powered
on. However, should you experience an excessively
long delay (over five minutes) for the link to be
established, press the HDMI/WVAN switch on the back
of the transmitter for at least three seconds to establish
the link (the receiver must also be powered on during
this process).
Mounting the receiver on a wall
For best performance, mount the receiver on
the wall next to the TV (or on the ceiling next
to a projector), with a clear view of the room.
It should NOT be mounted behind the TV or
projector. Try positioning the receiver above,
below, or next to the TV or projector and
check for best signal quality before securing
the mounting bracket to the wall or ceiling.
If mounting the receiver on the wall or ceiling
is not an option for your installation, the
receiver can be placed on a flat surface, but
the operating range may be reduced.
To mount the receiver on a wall:
1 Place the included receiver mounting bracket
on the wall or ceiling in the desired location
and mark the holes with a pencil.
Note: The mounting location should be within the
length of the included power cord to an available AC
outlet.
Transmitter
Cable/Satellite box
HDMI cable
Game console
Receiver
Display devices
HDMI cable
OR
RF-WHD210_11-0537_MAN_V1.fm Page 6 Tuesday, July 12, 2011 11:24 AM
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels